Architect7

Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)

Posted In:


  • Member
    Architect7 on · in reply to: FS: IB12AU Pair BNIB #11336

    Price lowered to $375 shipped, these are the 4 ohm version.

    Edit: Pending sale!


    Member
    Architect7 on · in reply to: FS: Dipole6 x4 and TD6H x2 #11233

    SOLD, thanks!


    Member
    Architect7 on · in reply to: FS: 6x OB15’s and 2x IB15HT’s #11077

    All 6 OB15’s and both IB15’s are sold.


    Member
    Architect7 on · in reply to: Shipping Ctns for IB15’s #10851

    Already have a buyer? If not, what impedance and what price are you asking?


    Member
    Architect7 on · in reply to: AVS Group Buy schedule #10819

    Does this group buy include the Dipole woofers?


    Member
    Architect7 on · in reply to: Power for 6 OB15’s? #10669

    Thanks John. These will be playing down to 20hz and perhaps a little below in an actively crossed over 3 way system. I have a high pass filter in place with a MiniDSP 2×8. I wanted to use 3 OB15’s per side to attain higher SPL without stressing the drivers too much. They will be playing as high as 300hz. Do you think 150 watts per driver would be sufficient?

    Thanks!


    Member
    Architect7 on · in reply to: Tweeter Selection For TD6M #10277

    I am about to receive my Dipole6 drivers and deciding on a suitable tweeter. My frontrunners are the ESS Heil AMT or the RAAL 140-15D Dipole. The Raal is definitely cost prohibitive but I want to do this right the first time around (I know I know, yeah right, nothig is done the first time in DIY 😉 However, the price of the Selenium driver above is very appealing. I know that would not be a true dipole solution but since I would be crossing over at 3khz, I do not believe that I truly need dipole above this point, correct?

    Any input is greatly appreciated. I wish I had the budget to evaluate them all 🙂


    Member
    Architect7 on · in reply to: Hello Simon or John. #10142

    @simon5 wrote:

    @architect7 wrote:

    Hello Simon-

    When you contact John, can you also check into OB15 availability/pricing/lead times?

    Thank you!

    OB15 will be made as soon as cones and VC are received, shouldn’t take too much time.

    Thank you. Can you verify pricing for four drivers and lead times? Also, how do I order? Thanks.


    Member
    Architect7 on · in reply to: Hello Simon or John. #10128

    Hello Simon-

    When you contact John, can you also check into OB15 availability/pricing/lead times?

    Thank you!

Viewing 9 posts - 1 through 9 (of 9 total)